10: Service Settings
EDS1100/2100 Device Server User Guide 74
2. Enter or modify the following settings:
Table 10-5 SNMP
3. Click Submit.
FTP Settings
The FTP web page shows the current File Transfer Protocol (FTP) configuration and various
statistics about the FTP server.
To configure FTP:
1. Select FTP on the menu bar. The FTP page opens to display the current configuration.
Figure 10-6 FTP Configuration
2. Enter or modify the following settings:
SNMP Settings Description
State Select Enabled to enable SNMP.
Read Community Enter the SNMP read-only community string.
Write Community Enter the SNMP read/write community string.
System Contact Enter the name of the system contact.
System Name Enter the system name.
System Description Enter the system description.
System Location Enter the system location.
Traps State Select Enabled to enable the transmission of SNMP Traps. The Cold Start
trap is sent on device boot up, and the Linkdown trap is sent when the
device is rebooted from software control.
Traps Primary Destination Enter the primary SNMP trap host.
Traps Secondary Destination Enter the secondary SNMP trap host.
To Next Page
Loading...
Need help?
General