Ensure adequate ventilation by leaving the required 5 cm (2 inch)
minimum gap around the sides of the instrument.
CAUTION
Do not block the ventilation holes located on both sides of the
oscilloscope.
CAUTION
Do not allow any foreign matter to enter the oscilloscope through the
ventilation holes, etc.
AC Power Source
100 to 240 VAC (+/-10%) at 50/60/400 Hz (+/-5%);Installation Category:
300V CAT II
No manual voltage selection is required because the instrument
automatically adapts to line voltage.
Power Consumption
< 50 Watts for all models (depending on accessories installed - probes, USB
devices, etc.).
Power consumption in Standby Mode: <5 Watts.
Power and Ground Connections
The instrument is provided with a 10A/250V 18AWGrated grounded cord
set containing a molded three-terminal polarized plug and a standard
IEC320 (Type C13) connector for making line voltage and safety ground
connections. The AC inlet ground terminal is connected directly to the
frame of the instrument. For adequate protection against electrical shock
hazard, the power cord plug must be inserted into a mating AC outlet
containing a safety ground contact.
To Next Page
Loading...
Need help?
General
