Menu Function Buttons
CURSORS - Press to turn on the cursors and display the Cursor
menu. You can use the Cursor menu to set the Cursor Mode (Auto,
Off, Manual, Track). When Cursors are on (CURSORS button is lit),
turn the Adjust knob to position the cursors.
ACQUIRE - Press to display Acquire menu. You can use the Acquire
menu to set the acquisition Sampling Mode (Sampling, Peak Detect,
Average). For more information on sampling modes, refer to
Acquisition Sampling Modes (on page 40).
SAVE/RECALL - Press to display the Save/Recall menu. You can use
the Save/Recall menu to save and recall up to 20 oscilloscope
setups or waveforms in internal memory (up to 20 waveforms) or
on a USB memory device (limited by memory capacity of USB
device). You can also use it to recall the default factory settings, to
save waveform data as a comma-delimited file (.CSV), and to save or
print the displayed waveform image.
MEASURE - Press to display a menu of measurement parameters.
The Display Type must be set to YT mode. For more information on
measurement parameters, refer to Parameter Measurements (on
page 54).
DISPLAY - Press to open the Display menu. You can use the Display
menu to set grid and waveform display styles, and persistence.
UTILITY - Press to open the Utility menu. You can use the Utility
menu to configure WaveAce features, such as sound, language,
counter, etc. You can also view system status and update software.
To Next Page
Loading...
Need help?
General
