Basic Operation Lexicon
2-10
REMOTE CONTROL OVERVIEW
The MC-8 remote control provides full operation of the MC-8,
including commands, such as menu navigation, that are not available
from the front panel. The command matrix, beginning on page 2-14,
indicates the commands that the remote control buttons perform
when each command bank is active. The numbered items in the
matrix correspond with the remote control illustrations.
OPERATION CONSIDERATIONS
The following factors can improve or impede remote control
operation.
Note the following before operating the MC-8 remote control:
• The remote control must be in line of sight with the front- panel
IR receiver. Eliminate obstructions between the remote control
and the IR receiver. The remote control may become unreliable
if strong sunlight or fluorescent light shines on the IR receiver.
• For optimal performance, position the remote control at a
30-degree angle no more than 17 feet (5m) from the MC-8.
Placing the MC-8 inside a smoked glass cabinet will reduce the
remote control range.
• Remote controllers for different components can interfere with
one another. Avoid using remote controls for different compo-
nents at the same time.
• Remote control batteries should be replaced as needed.
MAIN MENU
The MAIN MENU represents the beginning of
the menu structure. Use the MAIN MENU to
open the three main menu branches: MODE
ADJUST, AUDIO CONTROLS and SETUP.
MENU NAVIGATION
Use the remote control arrow buttons to navigate the extensive
menu structure shown in the Appendix. The table on the next page
indicates the navigation commands that the remote control
buttons perform when the Main Zone command bank is activated.
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
To Next Page
Loading...
Need help?
General
