3. Product Overview HDMI20-OPTC series – User's Manual 16
Neutrik OpticalCON QUAD Connector
dust and dirt.
QUAD
4
LC Connector
One channel of the Neutrik connector is not used by the extenders for signal
transmission and it is internally connected to the LC break-out connector in all models.
For more information about break-out connector see Application Example with Break-
out Connector section.
WARNING! Avoid eye exposure to beam! Direct intrabeam viewing normally hazardous.
INFO: Fiber optic cables can be easily damaged if they are improperly handled or installed. Handle the
optical cables with care to avoid damage.
HDMI Input and Output Ports
The extender provides standard 19-pole HDMI connector with screw lock.
ATTENTION! Always use high-quality HDMI cable for connecting sources and displays.
HDMI20-OPTC series extenders are supplied Neutrik etherCON connector (NE8FBH-S
switch or router by a CATx cable. However, both cable types (straight or cross) are
supported and handled by the device, below pin assignment is recommended.
Pin TIA/EIA T568 A Color and name TIA/EIA T568 B Color and name
1
2
green solid orange solid
3
4
blue solid blue solid
5
6
orange solid green solid
7
8
brown solid brown solid
Electrical Connections
Power Connectors
HDMI20-OPTC series has AC connectors, accepts 100-240 V, 50 or 60 Hz. Two different power connector
type is available:
Standard IEC C14 Connector
extenders are supplied with IEC C14 power connector.
Neutrik PowerCON TRUE 1 Connector
The HDMI20-OPTC-220-PCN extenders are supplied with NT PowerCON TRUE 1
Connector (NAC3MPX type).
Optical Connectors
HDMI20-OPTC series extenders transmit the video, embedded audio, Ethernet, and serial signal using
Neutrik OpticalCON Duo Connector
HDMI20-OPTC-220-PRO and HDMI20-OPTC-220-PCN extenders supplied with Neutrik
the transmitter to channel B on the receiver). The copper pins of the Neutrik connector
are not in use. Neutrik opticalCON DUO is compatible with 2x LC connector.
Fiberfox Connector
Only one channel is used (from channel A on the transmitter to channel B on the receiver).
The copper pins of the connector are not in use.
F
I
B
E
R
F
O
X
B
C
1
5
0
0
S
e
r
i
e
s
To Next Page
Loading...
Need help?
General