2. Installation HDMI20-OPTC series – User's Manual 12
Connecting Steps
Optionally connect a compatible Lightware device or a third-party device to the break-out LC
connector. It is internally linked to the channel B of the Neutrik connector.
Connect an HDMI source (e.g. video processor or media server) to any of the inputs of the
transmitter.
The displayed signal of the output port is equal to the extended video signal.
Optionally connect Ethernet devices (e.g. switch, laptop, computer etc.) to the available
Neutrik etherCON connector(s) of the extender(s). All connected devices will work as if they
are connected to the same network. Ethernet connectors are not Power over Ethernet (PoE)
compatible.
Optionally connect a USB mini-B type cable between the transmitter unit and the computer in
order to control the device (in this case only the transmitter).
Optionally for RS-232 extension: connect a controller unit (e.g. button panel) to the RS-232 port
of the transmitter with a null modem serial cable.
Connect the power cord to the AC power socket to the transmitter unit. It is recommended to
HDMI20-OPTC-RX220-Pro
HDMI20-OPTC-TX220-Pro
OPT
Video processor
Media server
Confidence monitor
4K projector
LCD screen
Power
LW or third-party
fiber device
Laptop
Ethernet switch
Button panel
Lightware or third-party
fiber device
HDMI HDMI HDMI
Power
OPT
USB
LAN RS-232
LAN
HDMI
HDMI
OPTPower
Power
LAN
HDMI
RS-232
HDMI20-OPTC-RX220
HDMI 2.0 Multimode Fiber Receiver
POWER / LIVE
FIBER LINK
HDCP
SIGNAL PRESENT
OUTPUT CONVERSION
CONTROL
FUNCTION
USB
HDMI20
OPTC
220
MAIN MENU
> System Settings
Ports
EDID
Health
Remote
POWER / LIVE
FIBER LINK
HDCP
INPUT 1
INPUT 2
CONTROL
SELECT
USB
HDMI20
OPTC
220
HDMI20-OPTC-TX220
HDMI 2.0 Multimode Fiber Transmitter
Optionally connect a compatible Lightware device or a third-party device to the break-out LC
connector. It is internally linked to the channel A of Neutrik connector.
Connect an HDMI sink (e.g. 4K projector) to the HDMI 1A and the 1B output ports and the other
sink (e.g. LCD screen) to the HDMI 2 output port.
In order to control, optionally connect Ethernet devices (e.g. 4K LCD screen) to the available
Neutrik etherCON connector of the extender.
Optionally for RS-232 extension: connect a controlled device (e.g. projector) to RS-232 port of
the receiver with a serial cable.
Connect the power cord to AC power socket to the receiver unit. It is recommended to power
ATTENTION! Connecting the transmitter and receiver to the same LAN beside they are connected to each
ATTENTION! Always use high-quality HDMI cable for connecting the sources with the transmitters, and
sinks with the receivers.
To Next Page
Loading...
Need help?
General