5. Software Control – Using Lightware Device Controller HDMI20-OPTC series – User's Manual 39
Settings Menu
Status Tab
The most important hardware and software related information can be found on this tab: hardware and
label can be changed to unique description by the Set button.
Network Tab
IP address and DHCP settings can be set on this tab. Always press the Apply changes button to save changes.
Factory default settings can be recalled with a dedicated button.
Front Panel Tab
Certain settings in connection with the front panel LCD are available in the LDC as well.
▪ LCD brightness:
▪ Lock front panel: disables the control functions (button and jog dial knob) on the front panel.
▪ Enable dark mode:
the dark mode in Front Panel Submenu section. The LEDs switch off after 60 s delay.
▪ Enable dark mode on a remote device*:
*Remote setting of the dark mode is available only in the transmitter.
To Next Page
Loading...
Need help?
General