Lightware SW4-OPT-TX240RAK User Manual

11.6. Factory default settings
Parameter Setting/Value
Video port settings
HDCP (DP, HDMI, DVI-D) Enabled
No sync screen mode Disabled
No sync screen clock source 480p
No sync screen pattern Bar
Output laser enabled On
Output HDMI mode Auto
Output HDCP mode Auto
Power 5V mode Always on
Selected video on optical output I1 input port
Autoselect mode Disabled, Priority detect, No change
Autoselect video priority
(SW4-OPT-TX240RAK)
0=DP, 1=HDMI, 2=HDMI2, 3=DVI-D
Audio port settings
Volume (analog audio) 0.00 dB
Balance (analog audio) 50 (center)
Gain (analog audio) 0 dB
Selected audio on optical output I1 input port
Autoselect audio priority
(SW4-OPT-TX240RAK)
0=DP, 1=HDMI1, 2=HDMI2, 3=DVI-D, 4=Analog1
in, 5=Analog2 in
Emulated EDIDs
DP input D1 – Dynamic EDID
HDMI input D1 – Dynamic EDID
DVI-D input D1 – Dynamic EDID
Network settings (SW4-OPT-TX240RAK)
IP address 192.168.0.100
Subnet mask 255.255.255.0
Static gateway 192.168.0.1
DHCP Disabled
LW2 Port number 10001
LW3 Port number 6107
HTTP Port number 80
RS-232 and GPIO settings
Control protocol LW2
Baud rate 57600
Databits 8
Parity No
Stopbits 1
Operation mode (Local and Local) Pass-through
Command injection port nr. (Local) 8001
Command injection port nr. (Link) 8002
GPIO direction Input
GPIO output level High
Page 104 / 106 Appendix

Lightware SW4-OPT-TX240RAK Specifications

General

Brand	Lightware
Model	SW4-OPT-TX240RAK
Category	Extender
Language	English