Port tiles
The colors of the port tiles and the displayed icons represent different states and information:
1
Port name
2
Port icon
3
Port number
4
Signal present indicator
green: present
gray: not present
5
State indicators
State indicators
Following icons display different states of the port/signal:
Icon Icon is gray Icon is black Icon is green
Signal is not encrypted
with HDCP
Signal is encrypted with
HDCP
-
Port is unmuted Port is muted -
Port is unlocked Port is locked -
Autoselect is disabled - Autoselect is enabled
6.4. Port properties and settings
Click on a port to display its properties; Signal status information and the most important
parameters are displayed. Special functions (e.g. frame detector, test pattern generator)
are also available on the panel. The look and the content are port-dependent.
6.4.1. Port name
The name of a port can be changed by typing the new name and clicking the Set button.
The following characters are allowed when naming:
Letters (A-Z) and (a-z), hyphen (-), underscore (_), numbers (0-9) and dot (.).
6.4.2. Mute/Unmute
The incoming/outgoing signal can be muted on the input and output ports. If the output is
muted, button text is “Muted”. When the port is muted, no signal is present on the output.
INFO
The mute/unmute setting can be set on the output ports independently from each other,
e.g. if LINKOUT is muted, LOCALOUT may be unmuted.
6.4.3. Lock/Unlock
The output ports can be locked by clicking on the button Unlocked. If the output is locked,
button text is “Locked”. If the port is locked, its mute state cannot be changed either by the
button or by loading a preset.
ATTENTION!
The lock/unlock setting cannot be set on the output ports independently from each other,
e.g. if LINKOUT is locked, LOCALOUT will be locked also.
LOCALOUT
A
2
5
4
1 3
O2
Mute
Lock
HDMI-3D-OPT-TX200 series
User’s manual
Software control Page 33 / 106
To Next Page
Loading...
Need help?
General