Lightware SW4-OPT-TX240RAK User Manual

8.5.19. HDMI mode settings (output ports)
Command format: SET●/MEDIA/VIDEO/<O
n
>.HdmiModeSetting=0|1|2
Response format: pw●/MEDIA/VIDEO/<O
n
>.HdmiModeSetting=0|1|2
Parameters:
.HdmiModeSetting 0 1 2
HDMI mode Auto HDMI DVI
Example:
˃ SET /MEDIA/VIDEO/O1.HdmiModeSetting=2
˂ pw / MEDIA/VIDEO/O1.HdmiModeSetting=2
8.6. Audio port settings
INFO
The settings described in the coming sections depend on the device as the input port
numbers are different. Port numbers are listed in section 11.2 on page 101.
8.6.1. Analog audio input level settings
INFO
The following settings are valid only for analog audio input ports.
Volume
Command format: SET●/MEDIA/AUDIO/<I
n
>.Volume=<level>
Response format: pw●/MEDIA/AUDIO/<I
n
>.Volume=<level>
Parameters:
<level> Sets the input volume (attenuation) between -95.625 dB and 0 dB
in step of -0.375 dB. The value is rounded up if necessary to match
with the step value.
Example:
˃ SET /MEDIA/AUDIO/I5.Volume=-15
˂ pw /MEDIA/AUDIO/I5.Volume=-15.000
Balance
Command format: SET●/MEDIA/AUDIO/<I
n
>.Balance=<level>
Response format: pw●/MEDIA/AUDIO/<I
n
>.Balance=<level>
Parameters:
<level> Sets the balance; 0 means left balance, 100 means right balance,
step is 1. Center is 50 (default).
Example:
˃ SET /MEDIA/AUDIO/I5.Balance=0
˂ pw /MEDIA/AUDIO/I5.Balance=0
HDMI-3D-OPT-TX200 series
User’s manual
LW3 programmers' reference Page 79 / 106

Lightware SW4-OPT-TX240RAK Specifications

General

Brand	Lightware
Model	SW4-OPT-TX240RAK
Category	Extender
Language	English