LORD W1 User Manual

14
WARNING
Risk of electric shock!
The appliance contains live parts.
Touching live parts is dangerous.
- Do not operate the appliance without a
cover cap.
WARNING
Risk of injury!
Whenusingtheapplianceonabase,the
appliance may tip over.
- Always secure the feet of the appliance
to a base using the manufacturer’s
“xing brackets” before using the
appliance for the rst time.
ATTENTION!
• Iftheapplianceisinstalledinareas
exposed to frost or outdoors, frozen
residual water may damage the
appliance and frozen hoses may crack
or split.
- Do not install or operate this
appliance anywhere that is liable to
experience frost and/or outdoors.
• Theapplianceunderwentafunction
test before leaving the factory and
may, therefore, contain residual water.
This residual water may leak out if the
appliance is tilted at an angle greater
than 40°.
- Tilt the appliance carefully.
Installation location Requirements
On a base Secure the
appliance with
“xing brackets”.
Installation location Requirements
On a wooden joist
oor
Place the
appliance on a
water-resistant
wooden
board which is
screwed tightly
to the oor. The
wooden board
should be at
least 30 mm
thick.
In a kitchen unit • Anichewidth
of 60 cm is
required.
• Onlyinstall
the appliance
underneath
a continuous
work top that
is securely
connected
to adjacent
cabinets.
On a wall Do not trap the
hoses between
the wall and the
appliance.
Removing the transit bolts
The appliance is secured for transportation
using transit bolts on the rear of the appliance.
Notes
• Pleasereadtheinformationinthe
“Safety” and “Preventing material
damage” sections to ensure that you
use the appliance safely.
• Keepthetransitbolts,screwsand
sleeves in a safe place for future
“transport”.

LORD W1 Specifications

General

Brand	LORD
Model	W1
Category	Washer
Language	English