LORD W1 User Manual

49
Sounds
Fault Cause Troubleshooting
Rushing, hissing noise. Waterisushedunder
pressure into the
detergent drawer.
• Notafault–normaloperatingnoise.
Loud noises during
the spin cycle.
Appliance is not
correctly aligned.
• Aligningtheappliance.
The appliance feet are
not xed.
• Securetheappliancefeet.Aligningthe
appliance.
Transit bolts have not
been removed.
• Removingthetransitbolts.
Banging noises,
rattling in the drain
pump.
Foreign bodies have got
into the drain pump.
• → “Cleaning the drain pump”
Slurping, rhythmical
suction noise.
The drain pump is
active, the detergent
solution is pumped out.
• Notafault–normaloperatingnoise.
Result problems
Fault Cause Troubleshooting
Creasing. The spin speed is too
high.
• Thenexttimeyourunawashcycle,seta
lower spin speed.
The load is too large. • Thenexttimeyourunawashcycle,
reduce the amount of laundry being
loaded.
The wrong programme
is selected for the type
of fabric.
• Selecttheprogrammesthataresuitable
for the type of fabric.
→ “Programmes”
Detergent or fabric
softener drips o the
seal and collects on
the door or in the seal
fold.
Too much detergent/
fabric softener in the
detergent drawer.
• Whendosingliquiddetergentand
fabric softener, observe the marking in
the detergent drawer and do not dose
above this.
The spin result is
not satisfactory. The
laundry is too wet/too
damp.
A low spin speed is
selected.
• Thenexttimeyourunawashcycle,seta
higher spin speed.
• StarttheSpin

programme.
Drain pipe or water
outlet hose is blocked.
• Cleanthedrainpipeandthewater
outlet hose.
Drain pipe or water
drain hose is caught or
jammed.
• Ensurethatthedrainpipeandwater
drain hose are not kinked or trapped.

LORD W1 Specifications

General

Brand	LORD
Model	W1
Category	Washer
Language	English