EasyManuals Logo
Home>LORD>Washer>W1

LORD W1 User Manual

LORD W1
59 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
34
Starting the programme
Note: If you want to change the time until
the programme ends, set the “Ready in”
time rst.
• PressStart - Pause.
The drum rotates and load detection
takes place. This can take up to 2
minutes, after which water enters the
drum.
The display shows either the
programme duration or the “Ready in”
time.
After the programme has ended,the
display shows: End.
Adjusting the “Ready in time
before the programme starts
You can readjust the selected “Ready in”
time before the programme starts.
1. Press Start - Pause.
2. Press Ready in repeatedly until the
display indicates the desired ”Ready in
time.
3. Press Start - Pause.
Soaking laundry
You can let the laundry soak in the
appliance by pausing the program.
Note: No additional detergent has to be
added. The soaking solution will be used
for washing.
1. Start the program.
2. After c. 10 minutes press Start - Pause
to pause the program.
3. After the required soaking time has
elapsed, press Start - Pause for the
program to continue.
Adding laundry
Note: Please read the information in the
“Safety and “Preventing material damage
sections to ensure that you use the
appliance safely.
1. Press Start - Pause.
The appliance is paused and checks
whether it is possible to add or remove
laundry. Take note of the programme
status.
2. Add or remove laundry.
3. Close the door.
4. Press Start - Pause.
Cancelling the programme
Once the programme has started, you can
cancel it at any time.
Note: Please read the information in the
“Safety and “Preventing material damage
sections to ensure that you use the
appliance safely.
1. Press Start - Pause.
2. Open the door.
The appliance door remains locked for
safety reasons if the temperature and
water levels are high.
If the temperature is high, start the
Rinse programme.
If the water level is high: Start the
Spin
or Drain programme.
3. Remove the laundry.
Resuming the programme
when the programme status is
Rinse Hold
1. Set the Spin
or Drain
programme.
2. Press Start - Pause.

Table of Contents

Other manuals for LORD W1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LORD W1 and is the answer not in the manual?

LORD W1 Specifications

General IconGeneral
BrandLORD
ModelW1
CategoryWasher
LanguageEnglish

Related product manuals