LORD W1 User Manual

45
Fault Cause Troubleshooting
The water pressure is
low.
No remedial action possible.
The lters in the water
inow are blocked.
• “Cleantheltersinthewaterinow”.
The tap is turned o. • Turnonthetap.
The water inlet hose is
kinked or jammed.
• Ensurethatthewaterinlethoseisnot
kinked or jammed.
: ashes. The automatic voltage
control system detects
an unauthorised voltage
under-usage.
• Noremedialactionpossible.
Note: If the power supply is stable, the
programme continues to run as normal.
. ashes. Voltage under-usage
may cause extension of
a programme.
No remedial action possible.

lights up. The temperature is too
high.
• Waituntilthetemperaturehasdropped.
• → “Cancelling the programme”
Waterlevelistoohigh.
• StarttheDrain programme.
aundry is caught in the
door.
1. Open the door again.
2. Remove any trapped laundry.
3. Close the door.
4. Press Start - Pause to start the
programme.

ashes. Door is not closed. 1. Close the door.
2. Press Start - Pause to start the
programme.
All other error codes. Malfunction • Calltheafter-salesservice.
→ “Customer Service”
Function faults
Fault Cause Troubleshooting
The appliance is not
working.
The mains plug of
the power cord is not
plugged in.
• Connecttheappliancetothepower
supply.
The circuit breaker is
faulty.
• Checkthecircuitbreakerinthefuse
box.
There has been a power
cut.
• Checkwhetherthelightinginyour
kitchen or other appliances are working.

LORD W1 Specifications

General

Brand	LORD
Model	W1
Category	Washer
Language	English