42
5. Reattach the water outlet hose and
secure the connection point using the
hose clamp.
Clean the water inlet lters
Clean the lter in the water inlet in the
event of blockages or if the water pressure
is too low.
Emptying the water inlet hose
1. Turn o the tap.
2. Set a programme, except for Rinse ,
Spin
or Drain .
3. Start the programme and leave it to
run for approx. 40 seconds.
4. Switch o the appliance.
5. Disconnect the appliance’s mains plug
from the power supply.
Cleaning the lter on the tap
Note: Please read the information in the
“Safety” and “Preventing material damage”
sections to ensure that you use the
appliance safely.
Requirement: The water inlet hose is
empty.
1. Remove the water inlet hose from the
tap.
2. Clean the lter with a small brush.
3. Connect the water inlet hose and check
for leaks.
To Next Page
Loading...
Need help?
General
