4 -11
1. Depress the clutch pedal and brake pedals.
Pull the throttle lever to “Low” speed position.
Place all the transmission gear levers in
neutral position and put PTO switch in “OFF”
position.
3. Apply the parking brake and release the
brake pedals and clutch pedal slowly.
2. Lower the implements to the ground and
turn key switch to “OFF” position.
(5) Stopping tractor
Mechanical type
1. Release the HST pedal slowly and pull the
throttle lever to “Low” speed position. Place
all the transmission gear levers in neutral
position and put PTO switch in “OFF”
position.
3. Apply the parking brake and release the
brake pedals slowly.
2. Lower the implements to the ground and
turn key switch to “OFF” position..
HST Type
Clutch pedal
Throttle lever
Brake pedals
Key switch
Parking brake lever
PTO switch
PTO switch
Brake pedals
Throttle lever
Parking brake lever
HST pedals
Key switch
Caution
▶ DO NOT leave the tractor with the transmission gear placed in neutral position and
the parking brake not applied. The tractor may roll down.
Apply the parking brake at all times before leaving the tractor.
▶ Remove the ignition key always after stopping engine.
To Next Page
Loading...
Need help?
General
