LS tractor MT225E User Manual

5 -23
②
Assembling filter element

Clean inside of the air cleaner housing with a clean damp cloth, being careful not to damage the
safety element (if fitted).

Check if there is damage of the filter element by using a light. If finding tiny cracks or small holes in
the filter element or damage of the gasket, replace it with a new one.

Insert the filter element deeply into the filter housing.

Remove dust of the evacuator valve and clean inside of the cover.

Assemble the cover with the evacuator valve facing downwards.

If the dust is not removed by tapping, use the
compressed air (less than 500kPa (5bar; 72psi))
from inside to outside as shown in the right
figure to remove the dust and dirt. And clean
inside the filter element with a clean damp cloth.
▶
Do not tap the element on a
hard place when cleaning.
▶
If the element is cracked,
change it with new one.
Notice
(6) Air cleaner (Dry type)
①
Cleaning filter element

Remove the cover and pull the primary element
straight out, ensuring the safety filter element(if
fitted) remains in place.

When cleaning the element in the working field,
tap the element by hand to remove the dust.
Primary
element
Evacuator valve
(Pressurized air)
▶
Do not assemble a wet filter element.
▶
Do not dry the wet filter element by using compressed air. It may cause damage to
the filter element.
▶
Do not start the engine or close the hood if the filter element is not assembled.
Notice
(5) Engine coolant

Before opening the radiator cap, cool down the engine coolant sufficiently.

See chapter 5-11-(1), Replacement of engine coolant” in this manual. (See page 5-41)

LS tractor MT225E Specifications

General

Brand	LS tractor
Model	MT225E
Category	Tractor
Language	English