LS tractor MT352 User Manual

4 -27
(3) Hitch and Drawbar (optional)
 When attaching towed equipment, use an
approved hitch or drawbar. DO NOT use the 3-
point linkage or other parts. If so, the tractor
could be overturned.
 When attaching/detaching towed equipment, be
sure to check the pins locked in place correctly.
 DO NOT exceed the maximum permissible
vertical and horizontal load of the coupling.
① Drawbar (w/clevis)
 It is used to connect a two-axle towed equipment.
 It is available to adjust the length of the drawbar
after removing snap pin and lock-pin in the right
figure. After adjusting, assemble the pins firmly.
 Vertical load : 350kg (when pulled) (772 lb)
450kg (when pushed) (992 lb)
 Horizontal load : 2.8 tonnes (6173 lb)
Drawbar
Unbraked towable mass N/A
Inertia-braked towable mass 2800kg (6173 lb)
Hydraulic & Pneumatic braked towable mass N/A
② Technically permissible maximum
towable mass(es)
 The maximum permissible towable mass is
depending on the brake system type on the
towed equipment as below. Check the brake
system of your towed equipment.
Snap pin
Drawbar
Lock-pin
When pulled
Regular position
When pushed
▶ Vertical loads on the coupling point of the drawbars, it may vary depending on the
tire load rating. Consult your authorized local dealer.
▶ Use always the drawbar or hitch for pulling work. DO NOT use the 3-point linkage,
rear axle or other parts. If so, the tractor could be overturned.
▶ When attaching/detaching towed equipment, apply the parking brake and stop the
engine before applying the locking pins manually.
▶ Before transporting equipment on public roads, make sure you comply with your
local traffic regulation.
Caution

LS tractor MT352 Specifications

General

Brand	LS tractor
Model	MT352
Category	Tractor
Language	English