LS tractor MT352 User Manual

5 -42
5-11. Every 600 hour check
Drain plug
Oil check port
& oil filling inlets
Oil filling inlet
& oil gauge
(1) Changing Front axle oil
 Stop your tractor on a level surface and apply
the parking brake. Clean around all the oil filling
inlets and drain plugs.
 Remove the drain plugs and oil filling inlets to
drain the oil completely.
 Wrap the sealing tape on the drain plugs and
tighten the drain plugs to its original position.
 Add new oil into the oil filling inlets according to
the capacity, and tighten the oil check port plugs
of the gear cases.
 For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
(2) Changing Transmission oil
 Stop tractor on a level surface and apply parking
brake. Run engine for several minutes to warm
oil and lower implements and stop the engine.
 Clean around the oil filling inlet and drain plugs.
 Set a clean container under drain plugs and
remove them under the transmission and drain
the oil completely.
 Clean metal sludge stuck to the drain plugs and
tighten the drain plugs again with copper washer.
 Add new oil until the oil level is between MIN and
MAX mark of the oil gauge.
 For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
Drain plugs
Copper washers
<Oil gauge >
Max.
Min.
Oil filling inlet,
Oil gauge
▶ Contaminated oil may reduce
the durability of transmission
drive lines and it can cause a
failure of the hydraulic system.
Clean around the oil filling inlet
and then pull the oil gauge.
Caution
Drain plug
 After about 5 minutes later, check if the oil level is marked between “Max” and “Min” marks of the oil
gauge. If the oil level is okay, install the oil gauge.

LS tractor MT352 Specifications

General

Brand	LS tractor
Model	MT352
Category	Tractor
Language	English