Maintenance work on the carrier
7.8 Angle gear
09.03.2018
Maintenance manual 3 302 746 en 7 - 57
GMK5200-1
7.8.3 Changing the oil and the oil filter
Oil, spare parts,
tools
– Connecting piece and hose (tool box).
– Two receptacles, approx. 10 l (2.5 gal); à p. 2 - 4.
– Key for the lock on the drain tap; à p. 7 - 58.
Prerequisites – The crane must be rigged with an outrigger span of at least 8.95 x 7.80 m
(29.4x25.6ft) and be level;
à Operating manual.
– The main boom must be fully retracted and fully raised; à Operating
manual
.
– The turntable must be turned to the 0° position to the rear; à Operating
manual
.
– The engine must be switched off and secured against unauthorised use;
à p. 2 - 3.
– The cover on the turntable over the centre of rotation must be removed.
– The hydraulic drives and the angle gear must have cooled down suffi-
ciently.
– The access opening and the interior space must be clean and free of oil so
that the fitter can work safely in the restricted space where the angle gear
is installed.
s
Gear oil in
litres (gal)
Designation to
DIN 51502
Specification
Classification
GROVE part no.
7.7 (2.0) MIL-L 2105 B
API-GL-5
Viscosity:
Hyp SHC 75-90
01373344
Designation Quantity GROVE part no.
Angle gear:
Gasket 30 x 36 Cu DIN 7603
1 00117151
Filter:
Filter
1 03135866
Packing set 1 04161645
To Next Page
Loading...
Need help?
General
