214 Part Number 80-1230-9 10/10
QF2200/QF2300
GEAR BOX REMOVAL
The evaporator and motor / gearbox are separate
assemblies. Warranty procedures require replacement
of the entire evaporator or motor /gearbox assembly.
Field rebuilding during the warranty period is not
allowed.
1. Disconnect power and water supply to the ice
machine and drain all water from the reservoir
and evaporator.
2. Remove reservoir retaining pin, water reservoir,
ice chute, and drain tubing (refer to Component
Removal).
3. Remove bolts securing foundation coupling to
base.
4. Lift and support evaporator (evaporator weighs 80
lbs.).
5. Remove gear motor drip shield and disconnect
line voltage wiring at motor Molex connector.
6. Remove two screws holding motor speed sensor
and remove sensor.
7. Remove bolts securing gear motor assembly to
base.
8. Remove gear motor assembly from ice machine.
9. Remove coupling (use a 8 mm hex wrench for
coupling set screw), spline hub and keyway from
gear motor.
To Next Page
Loading...
Need help?
General
