23
22
The Service Mode allows an authorized service provider to test and store information on the Climb Mill.
1) To enter Service Mode, press ENTER, 3, 0, 0, 1, ENTER on the lower keypad. Service Mode will appear on the display (Figure A).
2) Follow the prompts to change the desired setting.
3) Press the ENTER key once the desired setting is correct to save.
4) Press HOME to return to normal operation. note: If a setting has been changed, the unit and console power should be reset. Cycle the
power switch, and press and hold the CHANNEL UP and CHANNEL DOWN keys for 3-5 seconds to reset the console power.
FIGURE A
7.1 SERVICE MODE OVERVIEW
CHAPTER 7: SERVICE MODE
FUNCTION & DEFAULTS DESCRIPTIONS
Machine Type: Climb Mill This option selects the current model.
Serial Number This option displays the serial number of the console and frame.
Accumulated Floors This option displays the accumulated workout floors since production.
Accumulated Time This option displays the accumulated workout time since production.
Show Service on Boot Factory Setting Only.
SERVICE MODE
Setup
7.2 SERVICE MODE - SETUP TAB
CHAPTER 7: SERVICE MODE
To Next Page
Loading...
Need help?
General
