134
Controls in detail
Memory function
Prior to operating the vehicle, the driver
should check and adjust the seat height,
seat position fore and aft, and seat back-
rest angle if necessary, to ensure adequate
control, reach and comfort. The head re-
straint should also be adjusted for proper
height. See also the section on air bags
(
컄 page 70) for more information on prop-
er seat positioning.
In addition, adjust the steering wheel to
ensure adequate control, reach, operation
and comfort. Both the interior and exterior
rear view mirrors should be adjusted for
adequate rear vision.
Fasten seat belts. Infants and small chil-
dren should be seated in a properly se-
cured restraint system that complies with
U.S. Federal Motor Vehicle Safety Stan-
dards 213 and 225 and Canadian Motor
Vehicle Safety Standards 213 and 210.2.
With the memory function you can store up
to three different settings.
Each stored position on the driver’s side
includes the following settings:
앫 Driver’s seat, backrest, head restraint
position
앫 Multicontour seat*: previously saved
setting
앫 Steering wheel position
앫 Exterior rear view mirrors’ position
Each stored position on the front
passenger side includes the following
settings:
앫 Front passenger seat, backrest, head
restraint position
앫 Multicontour seat*: previously saved
setting
Warning! G
Do not activate the memory function while
driving. Activating the memory function
while driving could cause the driver to lose
control of the vehicle.
To Next Page
Loading...
Need help?
General
