246
Controls in detail
Panorama roof with power tilt/sliding panel*
Fully opening the roller sunblinds (Ex-
press-open)
왘 Move the roof panel/roller sunblinds
switch past the resistance point in di-
rection of arrow 1 and release.
The roller sunblinds opens completely.
Stopping the roller sunblinds during
Express-operation
왘 Move the roof panel/roller sunblinds
switch in any direction.
Opening and closing the panorama roof
with power tilt/sliding panel
The tilt/sliding panel is opened and closed
electrically. The switch for the tilt/sliding
panel is on the overhead control panel.
The tilt/sliding panel only operates with
the roller sunblinds opened.
Roof panel switch
1 Push back to slide roof panel open
2 Push forward to slide roof panel closed
3 Push up to raise roof panel
4 Pull down to lower roof panel
Warning! G
When closing the roller sunblinds, make
sure that no one is in danger of being injured
by the closing procedure. The closing of the
roller sunblinds can be immediately halted
by releasing the switch.
Warning! G
When opening or closing the tilt/sliding pan-
el, make sure that there is no danger of any-
one being harmed by the opening or closing
procedure.
The opening procedure of the tilt/sliding
panel can be immediately halted by releas-
ing the switch or, if the switch was moved
past the resistance point and released, by
moving the switch in any direction.
The closing procedure of the tilt/sliding
panel can be immediately halted by releas-
ing the switch.
The panorama roof with power tilt/sliding
panel is made out of glass. In the event of an
accident, the glass may shatter. This may re-
sult in an opening in the roof.
컄컄
To Next Page
Loading...
Need help?
General
