229
Controls in detail
4-zone automatic climate control
Adjusting air volume
Use buttons U (
컄 page 222) or
(
컄 page 223) for automatic mode or air
volume buttons or Q
(
컄 page 222) or (컄 page 223) to adjust air
volume manually.
Nine blower speeds are available.
왘 Press button to decrease or
button Q to increase air volume to
the desired level.
The
AUTO
indicator for air volume in the
display 4 (
컄 page 222) or
(
컄 page 223) goes out. The selected
blower speed is shown in the
display 4. Automatic air distribution
remains switched on.
The indicator lamps on the U but-
tons remain lit.
Front defroster
You can use this setting to defrost the
windshield, for example if it is iced up.
You can also defog the windshield and the
windows.
Activating
왘 Press button 0 or P
(
컄 page 222) or (컄 page 223).
The indicator lamp on the button
comes on. Display 4 (
컄 page 222) or
(
컄 page 223) is cleared.
The air conditioning switches
automatically to the following functions:
앫 cooling on to dehumidify
앫 maximum blowing and heating power
(depends on cooling temperature)
앫 air flows onto the windshield and the
front windows
앫 the air recirculation mode is switched
off
Deactivating
왘 Press button 0 or P
(
컄 page 222) or (컄 page 223) again.
The indicator lamp on the button goes
out. Defrosting is turned off.
The previous settings are once again in
effect.
i
Keep this setting selected only until the
windshield or the windows are clear again.
i
If you have switched on the defrost function
using the 0 or P button, you cannot make
any other settings.
i
The cooling remains switched on.
To Next Page
Loading...
Need help?
General
