On-board computer with steering wheel
buttons
X
Turn the key to position 2 in the ignition lock.
X
Press the y button.
The Aux. heat
submenu is shown in the dis-
play.
If no switch-on time has been selected, the
selected switch-on time is highlighted or
Timer off
is highlighted.
i
You can also access the Aux. heat. sub-
menu via the Settings
(Y page 168) menu.
X
Use the W or X button on the steering
wheel to select the desired switch-on time.
Use the Timer off
setting to deactivate
automatic switch-on.
X
Press the V button on the steering wheel.
The switch-on time is selected. The yellow
indicator lamp in the y button lights up.
Setting the switch-on time
X
Use the same method to select a switch-on
time as described in the "Preselecting a
switch-on time" section.
On-board computer without steering wheel
buttons
X
Press the 9 reset button on the instrument
cluster.
The hour display flashes.
X
Use the f and g buttons on the instrument
cluster to set the hours.
X
Press the 9 reset button
The minute display flashes.
X
Use the f and g buttons to set the minutes.
The switch-on time is set and selected.
On-board computer with steering wheel but-
tons
X
Press the 9 button on the steering wheel.
The display shows the Hours
menu.
X
Use the W and X buttons on the steer-
ing wheel to set the hours.
X
Press the 9 button.
The display shows the Minutes
menu.
X
Use the W and X buttons to set the
minutes.
X
Press the V button.
The switch-on time is set and selected.
Operation with the remote control
Important information
You can switch the auxiliary heating on/off and
set the operating duration using the remote con-
trol. You can use up to 4 remote control units on
the vehicle. These must be synchronized for the
receiver in your vehicle (
Y page 110).
The remote control has a maximum range of
approximately 600 meters. This range is
reduced by:
R
sources of interference
R
solid objects between the remote control and
the vehicle
R
the remote control being in an unfavorable
position in relation to the vehicle
R
transmitting from an enclosed space
Overview of the remote control
:
Indicator lamp
;
To confirm settings
=
To switch the remote control on/off, set the
operating duration or end or cancel settings
Indicator lamp : lights up in various ways to
show different operating modes:
Signaling Meaning
Lights up red Remote control switched on
Data transfer
Operating the auxiliary heating system
109
Climate control
Z
To Next Page
Loading...
Need help?
General
