Useful information
This Operator's Manual describes all models as
well as standard and optional equipment of your
vehicle that were available at the time of going
to print. Country-specific variations are possi-
ble. Note that your vehicle may not be equipped
with all of the described functions. This also
applies to systems and functions relevant to
safety.
Read the information on qualified specialist
workshops (
Y page 26).
Where will I find...?
Vehicle tool kit
General notes
The vehicle tool kit is in the stowage compart-
ment in the footwell on the front-passenger
side.
The vehicle tool kit consists of:
R
a towing eye
R
a screwdriver with Torx, Phillips and slotted
bits
If your vehicle is equipped with a spare wheel
bracket and a jack, the vehicle tool kit addition-
ally contains:
R
a wheel wrench
R
a spanner
R
a pump lever rod
i
The maximum payload of the jack can be
found on the sticker on the jack itself.
The jack is maintenance-free. In the event of a
malfunction, please contact a qualified spe-
cialist workshop.
Stowage compartment in the front-
passenger footwell
Unlocking and removing the cover
X
Turn quick-release fastener : counter-clock-
wise or clockwise 2.
X
Slightly raise and pull out the cover.
Removing the vehicle tool kit and the jack
X
Remove vehicle tool kit A.
X
Pull up quick-release lever = and unhook the
retaining strap of jack ?.
X
Lift jack ? upwards out of the holder.
i
When stowing away the jack, place it in the
holder as shown in the illustration. Make sure
that the retaining strap of the jack is hooked
in and tensioned.
Inserting and engaging the cover
X
Slide in the cover and fold it down.
X
Press down quick-release fastener : until it
engages.
240
Where will I find...?
Roadside Assistance
To Next Page
Loading...
Need help?
General
