X
Fold protective cover ? back into place.
X
Align lamp housing : on the left-hand side
and engage.
i
Vehicles with LED lighting: if an LED is
faulty, consult a qualified specialist work-
shop.
Cargo compartment lamp
Type of lamp: W 10 W
X
Switch off the interior lighting.
X
Undo screws : and remove the lamp lens.
X
Press bulb ; into the bulb holder and
unscrew it counter-clockwise.
X
Press new bulb ; into the bulb holder and
screw it in clockwise.
X
Position the lamp lens and tighten screws :.
i
Vehicles with LED cargo compartment
lamp: if an LED is defective, consult a quali-
fied specialist workshop.
Windshield wipers
Switching the windshield wiper
on/off
!
Do not operate the windshield wipers when
the windshield is dry, as this could damage
the wiper blades. Moreover, dust that has col-
lected on the windshield can scratch the glass
if wiping takes place when the windshield is
dry.
If it is necessary to switch on the windshield
wipers in dry weather conditions, always use
washer fluid when operating the windshield
wipers.
!
If the windshield wipers leave smears on the
windshield after the vehicle has been washed
in an automatic car wash, wax or other resi-
dues may be the reason for this. Clean the
windshield using washer fluid after washing
the vehicle in an automatic car wash.
!
Vehicles with rain/light sensor:
Switch the wipers off in dry weather. Other-
wise, dirt or optical effects may cause unde-
sired windshield wiper sweeps. This could
then damage the windshield wiper blades or
scratch the windshield.
The windshield will no longer be wiped properly
if the wiper blades are worn. Replace the wiper
blades twice a year (
Y page 94), ideally in
spring and fall.
Combination switch
X
Turn the key to position 1 or 2 in the ignition
lock.
X
Turn the combination switch in the direction
of arrow ; to the appropriate setting
depending on the intensity of the rain.
X
Single wipe: push the combination switch
briefly to the pressure point in the direction of
arrow :.
X
To wipe with washer fluid: press the com-
bination switch beyond the pressure point in
the direction of arrow :.
The detent positions of the combination switch
correspond to the following wiper speeds:
0Windshield wipers off
IIntermittent wipe
II Normal wipe
III Rapid wipe
Windshield wipers
93
Lights and windshield wipers
Z
To Next Page
Loading...
Need help?
General
