Transmission
Description and roadside assistance
77
Guidelines for Breakdown Services (Subject to technical modifications)
i
Teach-in errors
Teach-in or operating errors during the teach-in process are indicated by fault codes in the display. These fault
codes are not stored.
Fault code Cause Remedy
GS 06-GS 18/
GS
27/GS 29/
GS
32
Learning error 왘 Repeat teach-in process.
If this fault code reappears after the teach-in
process, have the fault rectified at a qualified
specialist workshop possessing the required
expertise and tools in order to perform the
necessary work. Mercedes-Benz recommends
a Mercedes-Benz service center for this work.
GS 19
Vehicle rolling. 왘 Apply parking brake.
GS 20
The display shows
U <<<
. 왘 Charge or replace the battery.
GS 21
The clutch pedal was released too early
or too late during the teach-in process.
왘 Depress the clutch pedal at the right time (lis-
ten for the warning buzzer).
GS 22
The neutral button was released during
the teach-in process.
왘 Press and hold down neutral button.
GS 23
Learning error 왘 Perform major teach-in process.
GS 24
Parking brake not applied during the
teach-in process.
왘 Apply parking brake.
GS 26
Engine running. 왘 Minor teach-in process: Switch off the engine.
왘 Major teach-in process: Do not start the engine
until the transmission neutral position flashes.
GS 28
Engine not started. 왘 Start the engine when the transmission neutral
position flashes.
GS 30
The accelerator pedal was operated
during the teach-in process.
왘 Do not depress the accelerator pedal during
the teach-in process.
To Next Page
Loading...
Need help?
General
