GENERAL INFORMATION
90-883728 JULY 2001 Page 1C-7
a. Remove remote oil hose (black without blue stripe) from pulse fitting on starboard
side of engine.
b. Drain any water from hose and reconnect.
c. If water was present in hose, check for water in the remote oil tank. Drain tank if
water is present.
15. Attempt to start engine, using a fresh fuel source. If engine starts, it should be run for
at least one hour to eliminate any water in engine.
16. If engine fails to start, determine cause (fuel, electrical or mechanical). Engine should
be run within 2 hours after recovery of outboard from water, or serious internal dam-
age may occur. If unable to start engine in this period, disassemble engine and clean
all parts. Apply oil as soon as possible.
To Next Page
Loading...
Need help?
General