FUEL INJECTION
Page 3B-50 90-883728 JULY 2001
4. Disconnect harness from pump to separate pump from cover. Inspect filter screen for
debris. Screen may be pried out of pump and cleaned as required.
5. Inspect seal above fuel pump for cuts or abraisions. Replace seal if necessary. Apply
2-4-C w/Teflon to seal lips.
d
a
b
c
58786
a-Filter Screen
b-Harness Connector
c-Pump
d-Seal (Seal shoulder
faces OUT)
6. Loosen screw securing float assembly and remove float. Inspect float for deterioration
or fuel retention. Replace float as required.
7. Remove gasket and inspect imbedded neoprene sealing bead on both sides of gasket
for cuts or abraisions. Replace gasket/seal assembly as required.
58787
b
a
c
d
58783
a-Screw
b-Float
c-Gasket
d-Sealing bead
Vapor Separator Reassembly
NOTE: Inspect VST cover gasket with sealing bead for cuts or abrasions. Replace if nec-
essary. Inspect fuel pump seal in VST cover for cuts or abrasions. Replace if necessary.
1. Install gasket w/sealing bead onto vapor separator cover.
2. Secure float, needle and pivot pin assembly to separator cover with screw. Torque
screw to 10 lb. in. (1.0 Nm)
To Next Page
Loading...
Need help?
General