OIL INJECTION
Page 3C-16 90-883728 JULY 2001
Prime the oil injection pump as follows:
1. Fill the engine fuel system with fuel. Connect fuel hose and squeeze primer bulb until
it fells firm.
2. Turn the ignition key switch to the “ON” position.
3. Within the first 10 seconds after the key switch has been turned on, move the remote
control handle from neutral into forward gear 3 to 5 times. This will automatically start
the priming process.
N
F
NOTE: It may take a few minutes for the pump to complete the priming process.
Remote Oil Hose Connections
NOTE: Oil hose with BLUE stripe contains a directional filter which is designed to trap any
debris in the oil before the oil reaches the engine oil reservoir. The filter is marked with
an arrow denoting direction of flow of oil and should be installed accordingly. Should en-
gine oil reservoir oil level drop while remote oil tank oil level is normal, oil flow through
inline filter has been reduced by debris and filter must be replaced.
CONNECTING OIL HOSE WITH BLUE STRIPE
1. Remove shipping cap from fitting and connect oil hose (b). Fasten hose with sta-strap.
a
b
58800
a-Directional Oil Filter b-Oil Hose with Blue
Stripe
To Next Page
Loading...
Need help?
General