MENU
[DOWN] [ UP ]
LOCAL LIGHT
[SAVE]
52644
Allows you to control the light level of the local
screen.
Speedometer Settings ‑ SCREENS
This calibration turns the system display screens on and off.
NOTE: Depending on the engine model and vessel options, not all screens will
apply.
1. Press the "MODE/SELECT" and "+" buttons simultaneously for
approximately four seconds until "SCREENS" is the display screen.
2. Press the "–" or "+" button to select the option choice displayed in the [ ]
brackets on the screen.
3. Press "MODE/SELECT" to save the setting and advance through the
calibration selections.
SCREENS
( NO )
( SAVE ) ( YES )
46462
TO WAYPOINT SCREEN ?
YES
To waypoint screen is displayed "YES" for on
or "NO" for off. GPS screens must be turned
on for this screen to be activated.
( NO )
( SAVE ) ( YES )
46463
WAYPOINT ALARM ?
YES
Waypoint alarm is displayed "YES" for on or
"NO" for off. GPS screens must be turned on
for this screen to be activated.
( DOWN )
( SAVE ) ( UP )
46464
WAYPOINT ALARM
DISTANCE = 0.3 MILES
Set the distance from the waypoint when the
alarm will become active. Press the "–" button
to decrease the distance or "+" to increase the
distance. The default distance setting is 0.3
mile
[ NO ]
[SAVE] [ YES ]
23542
STEERING ANG. SCREEN ?
YES
The steering angle is displayed "YES" for on or
"NO" for off.
23543
TEMP/CLOCK SCREEN ?
YES
[ NO ]
[SAVE] [ YES ]
The split screen showing air temperature and
time is displayed "YES" for on or "NO" for off.
SC 1000 SPEEDOMETER
30 eng
To Next Page
Loading...
Need help?
General
