Speedometer Display Screens
NOTE: Depending on the engine model and vessel options, not all screens will
apply.
0
SPEED
10
20
30
40
50
60
70
80
5:30 PM
70
60
F
AIR
F
SEA
FUEL 1
E
F
GAL90
E
F
TABS
STBD
PORT
FUEL 2
GAL
110
0% 0%
INST M/G AVG
1.5
3.2
RESET
46451
When the ignition is turned on, the speedometer will show the last screen that
was displayed before the ignition was turned off.
Press "MODE/SELECT" to change display screens. Revert back to the
previous screen by pressing and holding "MODE/SELECT" for two seconds.
NOTE: Readings can be displayed in English (U.S.) or metric. Refer to
Speedometer Screens
.
NOTE: The descriptions may not be in order on the gauge. The order may
change depending on engine type.
1.
Clock ‑ Temp: Clock, air temperature, and water temperature. The air
and water temperature sensors must be connected to obtain display
readings.
2.
Fuel 1: Displays the amount of fuel remaining in fuel tank 1.
3.
Fuel 2: Displays the amount of fuel remaining in fuel tank 2, water/waste
tank level (if applicable.) This screen will automatically display engine oil
tank for an OptiMax outboard.
4.
Tabs: Shows the position of the port and starboard tab viewed as a
percentage.
5.
Fuel Economy: Displays the average "AVG" fuel consumption as well as
instantaneous "INST" fuel economy. The numbers displayed indicate
miles per gallon "M/G" or kilometers per liter "KM/L." Fuel Reset: To
reset, select the display screen, press "MODE/SELECT" and "–"
simultaneously.
SC 1000 SPEEDOMETER
26 eng
To Next Page
Loading...
Need help?
General
