If the problem can cause immediate engine damage, the Engine Guardian
System will respond to the problem by limiting engine power. Immediately
reduce the throttle speed and refer to the warning messages on the following
pages. Refer to the Operation and Maintenance Manual for further
explanation of the problem and the correct action to take.
When a problem is detected, "SYS FAULT" screen will flash and the display will
show the fault location and information.
If the "MODE/SELECT" button is pressed to display a different screen, the
flashing alarm signal "AL" will appear in the upper‑right corner to indicate there
still is a problem.
Alarm Warning with Universal Codes
The "SYS FAULT" flashing screen appears
when there is a problem in the system.
The screen will alternately flash the text at
the top half of the screen, and at the
bottom half of the screen.
The text displays the fault location
("STBD," "PORT," "HELM 1," "HELM 2").
When there is more than one fault location,
the text will scroll. "MORE" displays the
fault code.
The fault is displayed as a numerical code.
The code description is listed in the
operation manual included with the
product. When there is more than one
code, "NEXT" displays the sequential fault
code.
Master Reset
Returns the gauge to the factory defaults through the Master Reset command.
IMPORTANT: Performing a Master Reset will reset the unit to the factory
defaults, thus eliminating any installation settings and calibrations performed
during set up of product.
PRODUCT OVERVIEW
eng 5
To Next Page
Loading...
Need help?
General
