Mercury SC 1000 User Manual

When the troll control is engaged and not in the troll control display screen, a
flashing "TR" signal will appear in the upper left corner of the screen to indicate
the troll control is still active.
SETTING TROLL CONTROL
a - Increase troll set speed
b - Decrease troll set speed
c - Setting is too fast, reduce set troll speed
d - Setting is too slow, increase set troll speed
e - Actual speed
f - Set speed
1. With the engine running, shift the engine into gear. Set the engine speed
at idle.
2. Press in either the "+" or "–" buttons to bring up the troll control display
screen.
3. Press "MODE/SELECT" to engage the troll control.
4. Use the "+" and "–" buttons to set the desired speed. Use "+" to increase
the set speed and use "–" to decrease the set speed.
5. If the troll speed is set to a higher speed than the troll control can
maintain, the "TROLL SPEED TOO FAST" display will appear. Reduce
the set troll speed.
6. If the troll speed is set to a slower speed than the troll control can
maintain, the "TROLL SPEED TOO SLOW" display will appear. Increase
the set troll speed.
0
1
2
4
5
7
6
3
RPM
X1000
0
SPEED
10
20
30
40
50
60
70
80
600
575
PUSH SELECT TO DISENGAGE
TROLL SPEED ON OFF
ACT
RPM
SET
RPM
TROLL SPEED ON OFF
PUSH SELECT TO DISENGAGE
3.0
2.5
ACT
MPH
SET
MPH
SET
MPH
TROLL SPEED TOO FAST
REDUCE TROLL SPEED
7.5
4.5
ACT
MPH
SET
MPH
TROLL SPEED TOO SLOW
INCREASE TROLL SPEED
3.0
2.5
ACT
MPH
c
d
46382
a
a
f
e
b
b
TROLL CONTROL
eng 35

Mercury SC 1000 Specifications

General

Brand	Mercury
Model	SC 1000
Category	Measuring Instruments
Language	English