Section 4 - Setup and Calibrations
90-8M0109374 eng JUNE 2016 Page 83
Selections for autopilot features are Cruise, Troll, Smart Tow, and Eco Mode. A Reset to defaults will uncheck any or all of the
autopilot features that are not available based on the power package of the vessel chosen in the Setup Wizard.
NOTE: If after the Reset to defaults option is chosen, all of the boxes are unchecked, your engine does not support the
autopilot features of the VesselView.
Cameras installed
Cameras installed allow the user to view videos or camera sources on the VesselView screen. VesselView supports two video
channels. You can select to view one channel only, or to cycle the screen between available video cameras. The cycle period
can be set from 5 to 120 seconds. The display can be optimized by adjusting the video settings. The adjustments are individual
to each source.
IMPORTANT: If the vessel does not have cameras installed, make sure that this option is unchecked. In certain situations, the
VesselView can experience disruptions in data display if the Cameras installed box is checked and the VesselView cannot
locate camera sources.
To Next Page
Loading...
Need help?
General
