Standard Controller MCAC-TSM-2008-02
90 Controller
8) Manual alarm acknowledgment and reset
Alarm messages blink. How to acknowledge an alarm is explained below.
All error messages are shown in the AL folder (see state Menu)
An error message will be shown,
alternating
with the error alert and the main
display.
The ALARM LED will be
permanently on.
An error can be acknowledged
by pressing any key once.
After pressing any key, the
alarm LED will start to blink.
MANUAL RESET
To manually reset an alarm,
press the “up” and “down” keys
together [UP+DOWN]
- - - - - - - - -
N.B: resetting an active alarm*
will save the alarm in the AL
folder (see state Menu).
* i.e. manual reset (alarm)
To Next Page
Loading...
Need help?
General
