Technical Information
153
G 1xxx/G 2xxx
3.25 Fault Code F36: Door Lock Switch Defective
Symptom:
The drain pump is operated, and any running program is interrupted.
See Table 080-3 for model-specific fault indications.
Cause:
S4 and S80 closed at the same time.
Remedy:
Replace the comfort door closing aid; see Section 020-4.9.
3.26 Fault Code F40: Electronic Fault
Symptom:
The dishwashing program is interrupted and the drain pump is operated.
See Table 080-3 for model-specific fault indications.
Cause:
The electronic has a fault that cannot be repaired by the service department
(such as a hardware fault).
Remedy:
Replace the electronic. See Section 100-4.5 or 100-4.6.
3.27 Fault Code F42: Line Frequency Registration Fault
Symptom:
The program is interrupted and the drain pump is operated.
See Table 080-3 for model-specific fault indications.
A check is carried out to ensure that the line frequency is within certain valid
ranges (50 ± 5 Hz or 60 ± 5 Hz). This fault is registered when it cannot clearly
be established which valid range is applicable.
Cause:
Main power supply not in order.
Remedy:
The main power supply should be checked by a specialist.
3.28 Fault Code F47: Faulty Interface Between Selection-Display
Electronic (BAE) & Control-Power Electronic (SLT)
Symptom:
The dishwashing program is interrupted and the drain pump is operated.
See Table 080-3 for model-specific fault indications.
Cause:
Communication between BAE and SLT faulty.
Remedy:
Replace the electronic. See Section 100-4.5 or 100-4.6.
To Next Page
Loading...
Need help?
General
