Technical Information
213
G 1xxx/G 2xxx
5. Release the Program button.
6. If the “Rinse & Hold” LED does not light up, repeat the procedure.
Acknowledgement indicator:
The “Rinse & Hold” LED flashes slowly (1 flash per second).
Options:
Function Programming Display
Software version ID check
Do not press the options
button. The “Tab” LED is
not lit.
The display shows the software
version ID no. in consecutive digits
(e.g., -818).
Display and delete fault
memory
Press the options button
once. The "Tab" LED
flashes once quickly
intermittently. Press the
Program button. Press it
again to display fault
codes that may have been
saved. To delete the fault
memory, press the
Program button again and
hold it for 4 s.
The display shows F and a fault
code number alternately (for a list of
fault codes, see the service
manual). If the fault memory is
empty, F and 0 are displayed
alternately. See Table 080-2 for a
list of fault codes.
Component test
Press the options button
2x. The “Tab” LED flashes
2x quickly intermittently.
Press the Program
button. Press it again to
activate the next
component.
The display shows which
component is being tested. For
example, if drain pump M8 is being
tested, U and 3 are shown
alternately. For the test sequence
and background information about
individual components and their
activation, see Section 080-2.2.
Operating hours check
Press the options button
3x. The “Tab” LED flashes
3x quickly intermittently.
The display shows the number
of operating hours as follows: If the
appliance has run for 74 hours, h, 7
and 4 are displayed alternately.
LED test
Press the options button
4x. The "Tab" LED flashes
4x quickly intermittently.
Press the Program button
once.
The display shows 6.1. All LEDs
light up.
Table 080-36: Service Mode Summary, G 1472/G 2472
4.3.6 Advanta - G 2020
Initial requirements:
1. Close the door.
2. Switch off the appliance.
3. Turn the selector switch to the 12 o'clock position.
Accessing:
1. Press and hold the Start/Stop button.
2. Switch on the appliance.
3. Release the Start/Stop button.
4. Immediately press the Start/Stop button 3 times; on the 3rd time, hold
To Next Page
Loading...
Need help?
General
