Initial commissioning
24
Reference to external appli-
ances
A reference to external hardware ap-
pears.
With machine
switched off
connect external
hardware, then
switch on, or
select "OK" to
continue
Touch the sensor control to read all
of the text in full.
Confirm with the OKsensor control.
Before initial commissioning, connect
the XCI box or slide a communication
module into the slot on the back of the
tumble dryer. The tumble dryer must
be disconnected from the mains for
this process. Then start the commis-
sioning process.
Setting the display brightness
Set the brightness you want with the
– and + sensor controls and confirm
your selection with the OKsensor
control.
The display will change to the next set-
ting.
Confirming the time request
Yes No
Should the clock display not
be shown?
Touch the yes or nosensor control.
If you select yes, the system will skip
the time setting.
If you select no, the display will switch
to the time setting.
Setting the time
OK
05:
12
Clock display
Use the andsensor controls to
enter the time and confirm your entry
with OK.
The display will change to the next set-
ting.
To Next Page
Loading...
Need help?
General
