4. Selecting programme settings
32
Selecting delay start
Delay start must be activated in the
supervisor level to allow it to be selec-
ted. In this case, one of these 3 sym-
bols also
lights up in the display: ,
, .
Touch the sensor control with the
clock symbol.
Depending on the delay start settings in
the supervisor level, different delays in
15-minute intervals can be selected:
– The programme finish time: Finish
at
– The programme start time: Start at
– The time to wait until the programme
starts: Start in
The maximum delay start period is 24
hours. The left-hand side of the dis-
play shows what you are able to enter.
Touch the or sensor controls to
select the hours and/or minutes.
Touch the OK sensor control.
If the delay start time is set to Finish
at or Start at, the current times will be
displayed.
Touch the OK sensor control.
The start delay begins when the pro-
gramme starts.
Changing/cancelling delay start
Before the programme starts
Touch the sensor control with the
clock symbol.
You can change or delete the time.
After the programme has started
Touch the Start/Stopsensor control.
You can either cancel the programme
or start it straight away.
To Next Page
Loading...
Need help?
General
