Supervisor level
83
Language
The display can be set to appear in
one of several different languages. To
select the language you want, go to
the Languages sub-menu.
You can change the language as fol-
lows:
– Permanently using the supervisor
level (=“Supervisor language”).
– For the duration of the current pro-
gramme only using the sensor
control. The supervisor language is
displayed again at the end of the pro-
gramme.
Brightness
The brightness of the display can be
set in intervals of ten from 10% to
100%.
Factory default: 70%
Clock display
After selecting the clock format, you
can set the time of day.
Clock format
– Factory default: 24-hour display
– 12-hour display
– Clock off
Set
– The time can be set.
Finish tone volume
The volume can be changed for the
audible signal that sounds at the end
of the programme.
It can be set to one of 7 different levels
or switched off altogether.
Factory default: Off
Keypad tone volume
An audible signal can also be activ-
ated that sounds when the sensor
controls are pressed; the volume of
this signal can be adjusted.
It can be set to one of 7 different levels
or switched off altogether.
Factory default: normal
Welcome tone volume
The volume of the switch-on signal
tone can be changed.
It can be set to one of 7 different levels
or switched off altogether.
Factory default: Off
To Next Page
Loading...
Need help?
General
