Settings
102
Display brightness
You can set the display brightness to
one of seven different levels.
Volume
A buzzer sequence will sound at the
end of a programme or if there is a fault
as long as the buzzers are activated.
Buzzers in the event of a fault
In the event of a fault, the alarm tone
will sound four times at intervals with a
short pause between each set of tones.
The alarm tone that sounds when
there is a fault cannot be
deactivated.
Buzzers
The buzzer at the end of a programme
will sound four times at intervals with a
short pause between each set of tones.
The volume of the buzzer at the end of
the programme can be selected from
one of seven levels. If no volume is
selected, the buzzer is switched off.
Keypad tone
An audible tone sounds each time a
sensor control is pressed.
The volume for the keypad tone can be
set to one of seven different levels. If no
volume is selected, the keypad tone is
switched off (except the On/
Offsensor control).
Welcome melody
If you switch the dishwasher on or off, a
brief melody will sound.
You can switch this melody off.
To Next Page
Loading...
Need help?
General
