Problem solving guide
76
Water inlet fault
Problem Cause and remedy
The warning buzzer is
sounding.
One of the following
messages appears in
the display:
Open stopcock
The stopcock is closed.
Open the stopcock fully.
Water intake
Before rectifying the problem:
Switch the dishwasher off.
The water inlet is restricted.
Open the stopcock fully and start the programme
again.
Clean the filter in the water inlet (see the “Cleaning
the filter in the water inlet” section in the “Cleaning
and care” chapter).
The water-connection pressure is lower than
50kPa.
Seek professional advice.
The on-site connection for the water drainage may
be too low and you will need to raise the water
drainage (see the “Hose installation” section in the
“Installation” chapter).
Fault F18
A technical fault has occurred.
Switch the dishwasher off.
Close the stopcock.
Call the Miele Customer Service Department.
To Next Page
Loading...
Need help?
General
