Settings
94
DOS flow rate
A flow rate of 60ml/min is set as
standard. The flow rate can be modified
between 10 and 150ml/min in
increments of 5ml/min.
Set the dosage according to the
detergent manufacturer’s
recommendations.
Choose the required detergent or
flow rate quantities and confirm your
selection with the OK button.
Venting the dispensing system
The dispensing system will not
dispense reliably if there is air in the
system.
The dispensing system must be vented:
- If the dispensing system is being
used for the first time
- If the liquid detergent reservoir was
not refilled in time and the dispensing
system was emptied
- If the detergent container was
replaced
To ensure that the dispensing
system functions properly, prior to
venting make sure that the detergent
container is full enough and that the
dispensing lances are firmly attached
to the containers.
Select Start venting and confirm your
entry with the OKbutton.
The venting process will begin.
Start the Cold pre-wash programme
directly after the venting process is
finished in order to dilute and drain any
detergent that escaped into the wash
cabinet.
Temperature unit
The temperature can be shown in the
display in degrees Celsius or degrees
Fahrenheit.
Select the setting you want and
confirm with OK.
Final rinse temperature
For better drying, the final rinse
temperature can be increased for
individual programmes. This function is
not available for all programmes (see
“Programme chart”).
Select the setting you want and
confirm with OK.
To Next Page
Loading...
Need help?
General
