Settings
98
RemoteUpdate
The RemoteUpdate menu option is
only displayed and can only be
selected if the requirements for using
Miele@home have been met (see
“Before using for the first time”
chapter, “Miele@home” section).
The RemoteUpdate function is used for
updating the software in your
dishwasher. If an update is available for
your dishwasher, it will automatically
download it. Updates will not be
installed automatically. They must be
initiated manually.
If you do not install an update, you can
continue to use your dishwasher as
usual. However, Miele recommends
installing updates.
Activating/deactivating
The RemoteUpdate function is
activated as standard. Available
updates will be downloaded
automatically and will only be installed if
you initiate them.
Deactivate RemoteUpdate if you do not
wish any updates to be downloaded
automatically.
Running a RemoteUpdate
Information about the content and
scope of a RemoteUpdate will be
provided in the Miele@mobile app.
A message will appear in your
dishwasher display if a software update
is available.
You can install the update immediately
or postpone this until later. When the
appliance is switched on again, you will
be reminded about the update.
Deactivate RemoteUpdate if you do not
want to install the update.
The update may take several minutes.
Please note the following information
about the RemoteUpdate function:
- You will only receive a message when
an update is available.
- Once an update has been installed, it
cannot be undone.
- Do not switch the dishwasher off
during the update. Otherwise, the
update will be aborted and will not be
installed.
- Some software updates can only be
carried out by the Miele Customer
Service Department.
To Next Page
Loading...
Need help?
General
