Operation
53
Program end
When a program ends normally, the LED for the Start/Stopbutton
goes out and the LED for the will flash. The message Program fin-
ished will appear in the bottom line of the display.
Normal plus
Temperature
Program finished
55 °C
In addition, a buzzer will also sound for approx. 3 seconds (factory
default setting). To adjust the buzzer volume, see "Settings , Vol-
ume".
If drying assistance has been enabled (see "Settings , Drying"), the
door will automatically open a few centimeters.
If the Switch-off function is enabled, the dishwasher switches itself
off after a short period of time.
Press the button to switch the dishwasher on again.
Turning off the dishwasher
Press the button until the button's LED goes out.
When the dishwasher is turned off, the set time of day appears in the
display.
You can also change the time of day display for when the dishwasher
is off (see "Settings, Time of day, Display").
Unloading the dishwasher
Dishes tend to break and chip more easily when they are hot. Allow
the dishes to cool until they are cool enough to handle before unload-
ing them.
The dishes will cool much faster if you open the door when the pro-
gram has ended.
First unload the lower basket, then the upper basket. This will prevent
water drops from the upper basket falling onto the dishes in the lower
basket.
To Next Page
Loading...
Need help?
General
