Miele TDA 150 C User Manual

Cleaning and care
26
Cleaning the condenser unit
Check the condenser unit once a
year and clean it if necessary.
Always check the fluff filters and the
condenser unit if the Clean out
airways indicator light comes on.
Detergent residue, hair and fine fluff
from the dryer can get through the fluff
filters and block the condenser unit.
Dust from the room in which the dryer
is installed can also get into the
condenser unit and cause a blockage.
Opening the service panel
 Use the yellow lever supplied to open
the service panel.
 Insert the lever into the middle of the
gap in the top (see arrow) and lever
the panel until it opens at the top.
 Now remove the panel by pulling it
diagonally upwards. Then place it to
one side.
 Turn the lever on the inner cover
downwards to the vertical position.
 Pull the cover forwards.
 Then remove it by pulling it diagonally
upwards.
 Turn the lever on the condenser unit
to the vertical position so that the
hook on the lever is no longer in the
groove at the bottom of the
condenser unit housing.

Miele TDA 150 C Specifications

General

Door hinge	Left
Cord length	2 m
Control type	Rotary
Loading type	Front-load
Drying system	Condensation
Product color	White
Built-in display	Yes
Appliance placement	Freestanding
Cycle time	109 min
Noise level	63 dB
Drying class	A
Drum capacity	7 kg
Delayed start timer	-
Current	16 A
Heat source	Electric
AC input voltage	220-230 V
Energy consumption	4.14 kWh
Annual energy consumption	494 kWh

Weight and Dimensions

Depth	580 mm
Width	595 mm
Height	850 mm
Weight	47000 g
Depth with door open	1060 mm