Problem solving guide
35
Changing the lamp
Disconnect the machine from the
mains electricity supply.
Open the door.
You will find the interior lamp cover at
the top of the drum aperture.
Insert a suitable tool* using light
pressure under the side edge of the
lamp cover as illustrated.
* E.g. a wide, flat-bladed screwdriver
Apply a little pressure and whilst
doing so turn your wrist in the
direction of the arrow to open the
cover.
The cover will open downwards.
The temperature-resistant lamp should
only be ordered from Miele.
The lamp must be replaced with
one of the same type and
specification. The lamp specification
and maximum wattage is stated on
the data plate and on the lamp cover.
Turn the lamp anti-clockwise to
remove it.
Replace the lamp.
To close the cover, push it upwards
and press it on the left and right until
you hear it click into position.
Ensure that it is fitted into
position securely, as any moisture
could cause a short circuit.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
